Hyper .21 Nitro Engine - PS, SlideValve, R-Exh, FOR PARTS

OFNA Hyper .21 (FOR PARTS ONLY) Stock Picture Used.

• Pull start is disassembled
• Engine has low compression.
• May need carb midrange reset.
• Includes brass crank collet.
• No clutch nut.
• Will idle, has issues mid-range.
• Includes new header and gasket.

This is one of the most popular aftermarket .21 sized enigines in the industry for 1/8th scale cars and trucks as well as Traxxas T-Maxx conversions.

FEATURES:
Oversized flow-through Black anodized cylinder head                  
ABC construction (Aluminum piston with a chromed brass cylinder)     
Rear exhaust                                                         
Ball Bearing-supported crankshaft                                    
Slide Valve rotatable Carburetor                                     
Needle valve adjusted by a screwdriver                               
Pilot Shaft                                                          
                                                                               
Includes: 
1 .21 Ofna Hyper engine w/Slide Valve Carburetor                   
1 Brass collet (these hold flywheel in place)                      
1 Header with seal, clamp and spring                               
1 Running and parts information sheets                             
1 Hyper .21 Decal sheet 
                                          
Specs: 
Displacement: 3.49cc  (.21 cubic inches)
Bore: 16.26mm      Stroke: 16.8mm                                       
Weight: 350g                                                            
Length: 85mm (3.355") from front of front bearing to back of pull start.
Width:  31mm ( 1.21") the width neglecting the mounting flanges, 36mm (1.43") distance across crankcase measured between the centers
Height: 113mm (4.428")                                                             
                                                                               
Requires: 
Fuel                                            
Muffler                                                             
Glow plug (long plug without idle bar)  

Please check to make sure your vehicle will accept a Rear Exhaust engine as well as a .21 sized engine. Fits most 1/8th scale cars and trucks.

Downloadable Manual Is Here:
http://www.ofna.com/pdf/53211-53210-HYPER-21.pdf