PUCKS 17.5 Drive System for TRL22 Buggy

“MIP Pucks™” ‘ARE’ the future of 17.5 stock racing! MIP’s all new Puck™ Drive system is an aluminum based drivetrain system which includes aluminum diff outdrives, aluminum C-CVD™ bones, and replaceable plastic orange wear Pucks™ that take the place of inferior steel pins. This combination greatly increases the longevity of the drivetrain and most importantly decreases the drivetrain’s overall rotating mass by a whopping 50%! The decrease in weight directly results in quicker acceleration, deceleration, and lower motor temps! Get the advantage that every stock racer craves! GET, MIP’s all new Hard Anodized 7075-T6 Aluminum Puck™ drive system!

TARGET CUSTOMERS:

17.5 Stock Racers

COMPETITIVE ADVANTAGES:

Less rotating mass

Quicker acceleration

Quicker deceleration

Lower motor temps

Less overall wear on drive components

FEATURES:

Complete MIP Differential

Complete C-CVD™ Axle Set

50% less rotating mass over stock steal components Replaceable Pucks to keep your drivetrain fresh Two sets of holes in the C-CVD™ bell

Hard Anodized 7075-T6 Aluminum

Race proven C-CVD™ Construct

MIP Laser Etched Logo

100% Quality made in the USA!

INCLUDES:

HW-SHSS 4-40 x 3/32 Cup Point (2), Ball Bearing 3/32” Chrome Steel Ball (14), HW-Pin 1/16 x .430 Solid Pin (2), HW-Pin 1/16 x 3/8 Roll Pin (2), HW-Nut M4 x .7mm Steel Locknut (2), HW- Bearing 1/16” Chrome Steel Ball (7), MIP Modified Diff Ring Losi 22 (2), HW-BHCS 1-72 x 1/8” (6), Washer #2 Hardened (1), MIP 3/16” CVD™ Coupling (2), MIP Capture Rings (2), Diff Spring 1⁄4 x 9/32” (1),HW-SHCS 2-56 x .92 Diff Screw (1), Molded T-Nut Associated (1), Diff Thrust cover (1), MIP CVDTM Puck Pin (2), MIP Outdrive PucksTM (8), MIP Thrust Retainer .236 Aluminum Bore (1), Diff

Lube & Grease cup (1), MIP Lube & Thread Gel Cup (1), Inst. Sheet (1), Confetti Sticker (2), MIP CVD™ Axle Losi 22 T (2), MIP Pucks™ Male Aluminum Outdrive TLR 22/22T/22 SCT (1), MIP PucksTM Female Aluminum Outdrive TLR 22/22T/22 SCT (1), MIP Pucks™ C-CVD™ Aluminum Bone TLR 22 T (1)

REQUIRES:

.050 Allen Key – Equivalent to #9000 MIP Hex Driver Wrench .050 inch

5/64 Allen Key – Equivalent to #9002 MIP Hex Driver Wrench 5/64 inch

COMPATIBILITY:

TLR 22 Buggy